Auto Page MA-200 Manual de Instruções descarregar pdf (Página 16)

Microscopy

This chapter describes the procedure of each microscopy.

See Table 2.1 for the items required for each microscopy.

• Refer to “4. Assembly,” when the product has not been assembled yet.

• For detailed information about operations of parts of the product, refer to “3. Operation Details.”

• Notes on using an external light source:

The procedures described on the episcopic illumination in 2.1 to 2.5 are based on use of the light source of

the MA200 main body with the LV-LH50PC Lamphouse attached. When using an external light source to

perform the microscopy, follow the notes below.

• The procedure on how to turn the power switch to ON: Turn on the power switch on the external device

in advance, then turn on the MA200 main body.

• Setting the Internal/External brightness control changeover switch of the MA200 main body: Sets to ON

(external mode).

• Adjusting the brightness of the light source: Adjusts the brightness on the external light source.

• To perform the epi-fl microscopy using the C-HGFI/C-HGFIE HG Precentered Fiber Illuminator as the

external light source, screw the compensation filter supplied with the fiber adapter into the MA2-FL

fluorescent unit. (Refer to 4.15.1.)

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 106 107

Sem comentários

Auto Page MA-200 Manual de Instruções Página 16